German
Flushing head for well drilling equipment made of stainless steel
Flushing head for well drilling equipment made of stainless steel
For detailed information about the flushing head please use this Link.
We supply the following flushing head:
Material: Stainless steel V2A (the entire flushing head)
Shaft connection on gear motor: diameter 22 mm and 100 mm deep
Outer diameter gear shaft: 46 mm Diameter
Adapter hole Connection for water outlet: 25 mm Diameter and preparation for our thread adapter. Any other adapter can also be connected.
Note: The ball bearings shown are only omitted because of the drawing view. Delivered are ZZ ball bearings, which are closed on both sides.
In the scope of delivery for self-assembly are included:
For detailed information about the flushing head please use this Link.
We supply the following flushing head:
Material: Stainless steel V2A (the entire flushing head)
Shaft connection on gear motor: diameter 22 mm and 100 mm deep
Outer diameter gear shaft: 46 mm Diameter
Adapter hole Connection for water outlet: 25 mm Diameter and preparation for our thread adapter. Any other adapter can also be connected.
Note: The ball bearings shown are only omitted because of the drawing view. Delivered are ZZ ball bearings, which are closed on both sides.
In the scope of delivery for self-assembly are included:
- The flushing head shaft
- The flushing head drum
- The two flushing head flanges for ball bearings and stuffing box packings for pressing
- The two ball bearings as closed version ZZ
- The retaining rings for shaft and bore
- The screws for positioning the flanges
- The studs for positioning and impressions when replacing the seal set
- The locking screws M10 for the connection to the motor shaft 2 pieces
- The cord seal 8x8 mm soaked as one piece to cut and install yourself
- The double nipple 3/4 inch for the water connection
- The flat nut as lock nut for the double nipple
| Shipping weight: | 6,8000 Kg |
